Sembra che si sia risolto seguendo le istruzioni del supporto tecnico 4iii che mi ha risposto in giornata, questa mattina ho fatto 100 km senza problemi, allego le istruzioni casomai servissero a qualcuno.
Please try the following:
Connect to the 4iiii app (iOS - 1.26.0; Android - 1.8.0) and ensure you have updated the power meter with the latest firmware (2.1.0).
Ensure you have an internet connection so the factory calibration values can be restored.
Please open your battery cap and gently nudge the two copper battery contacts with your finger to make sure they are well attached. There should be a little one near the
edge, and a large rectangular one in the centre.
If it looks like the large rectangular one is flat against the bottom, use a jeweller's screwdriver or similar tool to very gently lift the ends of the prongs 1mm off the bottom of the pod, so that they press against the battery more firmly.
Then, place an upside down (+ terminal down) battery into the pod so that it touches both of the battery contacts for a few seconds before reinstalling the battery in the correct orientation.
This will remove any residual charge.
Check the battery cap to ensure the metal clip is present:
Check locking tabs on body are undamaged:
Connect to your cycling computer:
Ensure power meter is awake (spin 4 times)
- Make sure you are paired to Left ANT+ ID
- Remove other ANT+ sensors from the cycling computer
Please also enable
"3rd Party Apps" in the 4iii app.