Eccco le istruzioni che hanno allegato ai miei adesivi:
To mount the decal, leaving the silicone release liner on the decal, separate the clear plastic film from the support
paper.
This is easiest done at a corner.
Now lay the decal down on a table with the support paper up, then holdin the clear plastic film and release liner down, peel
off the support paper. Care must be taken not to bend the film and the decal to much or to fast as this could cause them to
separe prematurely. Remove the silicon release liner and position the decal gently on the frame. It is imperative that the
decal be in correct position before you apply to much pressure. Rub the decal down with your fingers, being careful not to
trap air bubbles. At this point, using a clear dry rag, buff the decal down by rubbing the rag back and forth.
This serves three purposes: first it bonds the adhesive to the frame with a combination of heat and preassure; secondly, the
rubbing loosens up the releasing agent that is bonded to the backside of the clear film; thirdly, rubbing the decal down
before squeegeeing the decal down will eliminate the possibility of stretching the decal while squeegeeing.
You can also use a credit card or a similar type plastic.
This in turn will eliminate stress cracks, which could appear up to 2 weeks after mounting.
Burnish the decal down with some sort of hard burnisher: a bonde sqeegee or some other form of hard plastic applicator works
the best. Be sure to burnish down the entire decal, reburnish the decal again.
This second burnishing will cause the clear stock to move laterally, which separates the clear form the now mounted decal.
This is how the release is achieved. Slowly peel back the clear flm making sure all areas of the decal have released
properly. If any haven't reburnish again.
Ci vorrebbe qualcuno che abbia già applicato i dannati vinilici per avere la dritta giusta!